Whirlpool: Difference between revisions
Appearance
imported>NoteBot CBB Podcast 506 (Off Script and Milieu) notes |
imported>NoteBot CBB Podcast 506 (Off Script and Milieu) notes |
(No difference)
| |
Revision as of 22:00, 29 October 2026
Tight cones
Achieving a Tighter Trub Cone in a Whirlpool - LM Notebook
Whirlpool Design and Operation
- Optimal Dimensions: Aim for a height to diameter ratio (H/D) of 0.5-1.0, with newer installations favoring lower values. This ratio promotes faster settling due to the larger diameter and reduced height.
- Control Wort Entry Velocity: The entering wort stream volume should be proportional to the H/D ratio. The entry velocity should be 3.5-5 m/sec, injected at a 20-30° angle to the vessel tangent, about 1 m from the vessel floor for maximum energy conversion efficiency. A flow rate below 2.4 m/sec during transfer from the kettle helps minimize trub floc break-up.
- Appropriate Base Design: Shallow, conical bases with angles around 30° are favorable for trub cone formation.
- Minimize Secondary Eddies: Install an annular, horizontal metal grid or rings to disrupt undesirable eddy currents that interfere with trub sedimentation.
- Control Wort Withdrawal: Slow down wort withdrawal as the trub cone becomes exposed to prevent slumping and spreading. Consider multiple wort draw-off points at varying heights to allow for drawing off clearer wort as the vessel empties.
Upstream Brewing Practices
- Grist Composition and Milling: A coarser grist with a larger husk particle size improves lauter grain bed permeability and ultimately contributes to better trub formation.
- Mashing Process: Avoid excessive shear forces during mashing to prevent the formation of gelled proteins, which can hinder trub formation.
- Wort Transfer: Minimize shear forces during wort transfer from the kettle to the whirlpool by using a slow-running pump with an open-throated impeller and maintaining a transfer velocity below 1.3 m/s.
Hazy IPA: CBB 506
CBB 506 - Off Script and Milieu
- Whirlpool at 165°F (about 74°C), fast, to knock out the big proteins and leave smaller ones in suspension for haze and mouthfeel.
- About 2 lb per barrel (about 7.7 g/L, calculated; first heard as 1, corrected to 2). I don't remember which brewer, and the transcript can't tell.
- Also from the episode page (not from my notes): whirlpool aggressively for better haze stability, and keep hop matter out of the kettle before the whirlpool.